Charging Pedestals
TYZ-CR300 Low-Profile Folding Arm Cable Retractor
Reduced-height folding arm retractor for installations with limited vertical clearance — under canopies, inside garages or beside compact equipment. 20 kg working load.
When headroom is the constraint
Canopies, basement garages and compact equipment rooms often leave too little vertical space for a standard retractor. The TYZ-CR300 uses a reduced-height profile so the arm still folds cleanly without clashing with the structure above.
Stable travel, low operating effort
The main shaft uses a coil spring return with an auxiliary torsion spring, and the section profile is 60 × 30 mm aluminium alloy. Operating torque stays at or below 3 kg, so drivers can pull the cable without effort.
Where it fits
- Canopy and shelter installations — minimal vertical clearance
Basement and covered parking — low ceiling heights
- Compact equipment rooms — tight mounting envelopes
Retrofit sites — where a standard arm will not fit
Arm configuration
Main arm length is customizable from 300 to 700 mm, with a 300 mm auxiliary arm, up to 1000 mm combined. Main arm rotation is 180°, auxiliary 135°.
Get a specification sheet
Tell us the available clearance and the charger position, and we will confirm whether the low-profile arm is the right fit and share the specification sheet.
Specifications
Model: TYZ-CR300
Type: Low-profile folding arm retractor
Max working load: 20 kg
Profile section size: 60 × 30 mm
Main arm length (A): 300–700 mm (customizable)
Auxiliary arm length (B): 300 mm
Total length (A+B): ≤ 1000 mm
Rotation angle: Main arm 180° / auxiliary arm 135°Return mechanism: Main shaft coil spring; auxiliary shaft torsion springOperating torque: ≤ 3 kgMaterial: Aluminium alloy, powder-coatedService life: Over 150,000 cycles